E-Z-GO Golf Cart Chargers: Which Charger and Plug Your TXT or RXV Takes

Some links on this site are affiliate links: if you buy through them we earn a commission, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.

Your E-Z-GO charger quit, or the new one you ordered will not seat in the receptacle. The usual mistake is shopping by cart name alone. What matters is two things: the voltage and battery type on the charger label, and the plug that fits the socket on your cart. PowerWise, QuiQ and ELiTE are charger names, not plug shapes.

An E-Z-GO golf cart plugged in to charge in a parking garage
Photo: Infrogmation, CC BY-SA 4.0, via Wikimedia Commons (cropped)

At a glance

  • Match two things: pack voltage and battery type on the charger label, and the plug that fits your cart's receptacle.
  • Plugs: 2-pin on PowerWise-style 36 V and 48 V carts, 3-pin on RXV and 48 V TXT. Count the pins in the socket.
  • Red flashes: one to six, each a different fault; six that returns goes to a service center.
On this page (7)

Which charger does my E-Z-GO use?

Where E-Z-GO names the charger in its own manuals and sell sheets, this is what it prints. Older 36 V TXTs and pre-2024 lead-acid RXVs are not in the list because E-Z-GO does not print a charger for them.

Model and versionModel yearsPackCharger as E-Z-GO names it
TXT Fleet and Freedom, electric2014 on48 V48 V high-frequency, 13 A DC out, 8 A AC in
RXV and TXT electric fleet cars201548 VDelta-Q SC-48
Valor, lead-acid2024 on48 VDelta-Q QuiQ, algorithm chosen for the battery
RXV ELiTE, lithium2024 onLithiumQuiQ 913-4830, RC900 on-board 944-0003, or ELiTE Charger 958-0001 to 958-0004
RXV 42026 onLithiumLight World Charger, 56.7 V

PowerWise QE is E-Z-GO's name for the TXT-era charger, built with Delta-Q, sold in 36 V and 48 V versions. On an ELiTE, three chargers share one manual, so read the part number off the charger label and go to that appendix.

How to confirm what you have

Check three things before you buy, in this order:

  1. The charger label. It gives the part number, 36 V or 48 V, and the battery type the charger is built for. The PowerWise QE 48 V manual says plainly: use it only on 48 volt systems.
  2. The receptacle on the cart. On a TXT 48 it sits on the driver side, just below the seat bottom. Count the pins while you are down there.
  3. The pack itself. Lift the seat and read the battery labels; the number and voltage of the batteries tell you the pack voltage. The layouts for each E-Z-GO are set out by model and year.

If you are unsure of the model year, the serial plate gives model and year, and the E-Z-GO model guide shows where it sits on each one.

Two pins or three?

E-Z-GO's own manuals never name a plug shape. They say the DC cord ends in a polarized connector that fits a matching receptacle. The 2-pin and 3-pin names owners search for come from the charger makers and the parts retailers.

Lester's connector table lists two separate E-Z-GO plugs: "E-Z-GO PowerWise 2-Pin 36V or 48V" with two wires, and "E-Z-GO 3-Pin Molded RXV & 48V TXT" with three. FORM Charge calls its three-pin version the EZGO Triangle Plug and lists it for RXV 2008 on and TXT 2014 on, while retailers list the 3-pin Lester charger from RXV 2008 and TXT 2010: charger-maker and retailer listings, not E-Z-GO's. Retailers also sell a notched 2-pin Powerwise-style plug for other 48 V E-Z-GOs, and a D-shaped Powerwise-style plug on 36 V TXT and Medalist lead-acid chargers.

The third pin does real work. Delta-Q compensates the charge for pack temperature through it on the SC-48 and World Charger, and the plug also carries the drive lockout that stops the cart moving while it is charging.

Tip: If a 3-pin cordset is fitted to a Lester charger in the field rather than at the factory, Lester says a new System Profile has to be uploaded through its app before the vehicle lockout works. A shop-built cord can charge fine and still leave the cart drivable while plugged in.

What the lights and red flashes mean

On a 48 V TXT, green tells you where the charge is and red counts out a fault.

LightWhat it means
Short green flashLess than 80 percent charged
Long green flashMore than 80 percent charged
Solid greenFully charged
1 red flashPoor contact or dirty DC connector, or battery temperature above 122°F (50°C) or below 14°F (-10°C)
2 red flashesBattery voltage fault
3 red flashesCharge time-out
4 red flashesBattery fault: the pack is not reaching nominal voltage in the maximum time
6 red flashesInternal charger fault

E-Z-GO's two documents disagree on the thresholds behind two of those codes: the TXT 48 owner's guide prints a voltage fault below 48.0 V and a time-out at 24 hours, while the PowerWise QE 48 V manual prints 36.0 V and 12 hours for the same codes. Either way the action is the same: clean the contacts, then have the pack tested.

ELiTE chargers give no flash numbers. Check the green DC paddle and receptacle for damage and corrosion, then reset by cutting AC power for 15 seconds or more. A battery management fault goes to the service department. QuiQ and Lester chargers count their own codes, so read a flash count against the manual for the charger in your hand.

Aftermarket and lithium chargers

E-Z-GO's TXT guide allows a non E-Z-GO charger and tells you to follow that charger's own instructions; it also warns that parts which are not OEM approved may void the warranty. On the aftermarket side, by what the makers print: the Lester Summit II 650W has an Auto Voltage Mode that handles both 36 V and 48 V packs from one charger, with the caution to verify the active battery profile before use. The FORM 48 V 15 A charger lists the PowerWise QE, QuiQ and SC-48 part numbers it replaces and comes with the three-pin triangle plug for RXV and 48 V TXT.

An ELiTE takes E-Z-GO's OEM approved lithium charger only: its QuiQ label permits 48 V lithium packs activated by Samsung SDI and nothing else. A lead-acid E-Z-GO converted to lithium takes the pack maker's own charger and charge port, which is covered on the general charger page.

Tip: If several carts on the same circuit charge incompletely in a normally adequate time, E-Z-GO points at low AC voltage rather than the chargers. Charger output follows input voltage, so a long or thin extension cord shows up as a slow charge.

Where to stop

  • Give each charger its own dedicated 15 A circuit, with nothing else plugged into it.
  • Charge with good ventilation: lead-acid packs give off hydrogen, and E-Z-GO asks for at least five air exchanges an hour.
  • Do not leave a charger on an unattended cart beyond the normal charge cycle; check it after 24 hours and unplug when it is done.
  • Six red flashes that come back after unplugging and replugging the DC cord, or any ELiTE battery management fault, goes to a qualified service center or E-Z-GO Customer Care.

Common questions

Should I leave my E-Z-GO plugged into the charger all the time?

The TXT Freedom 48 guide allows it, provided the charger stays plugged into a live outlet, because if the power is interrupted the charger keeps checking the pack and can drain the batteries. The TXT Fleet guide says to unplug once the cycle finishes. Plugged in is safe only on a circuit you trust.

How long does an E-Z-GO charger take to charge the pack?

Delta-Q's 2016 sheet gives an estimated 6.7 hours at 75 percent depth of discharge for both the SC-48 and the World Charger at 48 V. On a 48 V TXT the charger times out at 24 hours, which is a fault, not a normal charge.

Why does my E-Z-GO charger plug rattle?

A loose fit in the receptacle is what E-Z-GO's one-red-flash code describes as poor contact or dirty DC connector contacts. Clean both halves and check the pins for burning or corrosion before buying a charger: the cordset is a replaceable part on most chargers.